download win10 driver ft232r usb uart ftdi

#DOWNLOAD WIN10 DRIVER FT232R USB UART FTDI SERIAL#
#DOWNLOAD WIN10 DRIVER FT232R USB UART FTDI DRIVERS#

Highly integrated design includes 5V to 3.3/+1.8V LDO regulator for VCORE, integrated POR function.Bit-bang Mode interface option with RD# and WR strobes.Option for transmit and receive LED drive signals.

#DOWNLOAD WIN10 DRIVER FT232R USB UART FTDI DRIVERS#

FTDI’s royalty-free Virtual Com Port (VCP) and Direct (D2XX) drivers eliminate the requirement for USB driver development in most cases.

CPU-style FIFO interface mode simplifies CPU interface design.

Supports a half duplex FT1248 interface with a configurable width, bi-directional data bus (1, 2, 4 or 8 bits wide).

USB to synchronous 245 parallel FIFO mode for transfers up to 40 Mbytes/Sec.

USB to asynchronous 245 FIFO mode for transfer data rate up to 8 MByte/Sec.

(RS232 Data Rate limited by external level shifter).

UART transfer data rate up to 12Mbaud.

#DOWNLOAD WIN10 DRIVER FT232R USB UART FTDI SERIAL#

Multi-Protocol Synchronous Serial Engine (MPSSE) to simplify synchronous serial protocol (USB to JTAG, I2C, SPI or bit-bang) design.

USB 2.0 Hi-Speed (480Mbits/Second) and Full Speed (12Mbits/Second) compatible.

No USB specific firmware programming required.

Entire USB protocol handled on the chip.

Single channel USB to serial / parallel ports with a variety of configurations.

This 48 pin device is available in either LQFP or QFN packaging, and is ROHS compliant. FTDI provides royalty-free virtual com port and D2XX drivers for Microsoft Windows (XP – Windows7), Apple Mac OSX, and Linux.

On-board voltage regulation provides 3.3V and 1.8V supplies from a 5V source, as well as a power-on-reset function. The I/O structure is 3.3V with built-in tolerance for 5V, allowing the designer maximum flexibility when interfacing with FPGAs. In addition, this device features the new synchronous, half-duplex FT1248 bus, which allows an engineer to trade off bandwidth for pin count using 1, 2, 4, or 8 data lines at up to 30Mbytes/s. Using a serial EEPROM interface, this device can be configured for a wide variety of asynchronous and synchronous serial standards, such as JTAG, SPI, I2C and UART as well as synchronous and asynchronous parallel FIFO interfaces. Operating at USB Hi-Speed 480Mbps rate, this fast single channel bridge chip features either a flexible serial interface or parallel FIFO interface, with data transfer speeds up to 40Mbytes/s. With added Power Delivery(PD) functionality to the existing High Speed Series. USB High Speed Power Delivery Series are now available here.

FT232H – Hi-Speed Single Channel USB UART/FIFO IC

Download win10 driver ft232r usb uart ftdi